Fs-Fn Adjustment - Tri-Fold Position - Olivetti d-Color MF651 Service Manual

12. SERVICE MODE

12.16.12 FS-FN adjustment - Tri-Fold Position

A. Use
• Use this adjustment to adjust tri-fold position in tri-fold printing.
B. Procedure
1. Make a copy sample in the tri-folding mode.
2. Check that the tri-fold positions (a, b, c) on the copy are within the specified range.
Folding position
a
b
c
Adjustment range: -10.0 mm to +10.0 mm (1 step: 0.1 mm)
3. Call the Service Mode to the screen.
4. Touch [Finisher]
5. Touch the paper size where tri-fold position is adjusted.
6. Look at the copy and adjust the tri-fold position with the [+]/[-] key.
To make width (a) greater : Enter the value of [+]
To make width (a) smaller : Enter the value of [-]
7. Press the Reset key.
8. Touch [Exit] on the Service Mode screen.
9. Turn OFF the main power switch, wait for 10 sec., then turn the switch ON.
10. Make a copy again and check the 1st fold width "a".
NOTE
• If the 2nd fold width b is not within the specified range, perform mechanical
adjustment.
See P.20 of the SD-508 service manual.
606
c
a
b
Standard value
A4S 8.5 X 11A
95mm 89.4mm
101mm 95mm
101mm 95mm
[FS-FN adjustment]
Service Manual
Field Service Ver. 2.0 Jul. 2009
16KS
88mm
91mm
91mm
[Tri-Fold Position].
A11RF3C500DA
Standard
±2mm
Y110571-1