Chapter 1 Part Names - Mitsubishi Electric NZ2GF2S-60IOLD8 User Manual

1
PART NAMES
This section describes part names of the IO-Link module.
(1) (2) (6)
(8) (9)
No. Name
(1) P1
L ER LED
LINK LED
P2
L ER LED
LINK LED
(2) PW LED
RUN LED
MODE LED
D LINK LED
ERR. LED
(3) CH1 to CH8 LED (green)
CH1 to CH8 LED (yellow)
(4) CH1 to CH8 ERR. LED
(5) I/O PW LED
(6) Function setting switch
(7) (3) (4) (5)
(10) (9)
Application
PORT1 connector for CC-Link IE Field Network (RJ45 connector)
An Ethernet cable is connected. ( Page 37 Wiring of Ethernet cable)
• On: Module received abnormal data, or module performing loopback
• Off: Module received normal data, or module not performing loopback
Indicates the link status
• On: Link-up in progress
• Off: Link-down in progress
PORT2 connector for CC-Link IE Field Network (RJ45 connector)
An Ethernet cable is connected. ( Page 37 Wiring of Ethernet cable)
(Same as the LEDs of P1 connector)
Indicates the power supply status of the IO-Link module.
• On: Power supply ON
• Off: Power supply OFF
Indicates the operating status of the IO-Link module.
• On: Operating normally
• Off: A major error has occurred.
Indicates the mode of the IO-Link module.
• On: Online mode
• Flashing: Unit test mode
• Off: In offline mode, or the unit test is completed.
Indicates the data link status of the IO-Link module.
• On: Data link in operation (cyclic transmission in progress)
• Flashing: Data link in operation (cyclic transmission stopped)
• Off: Data link not performed (disconnected or in unit test mode)
Indicates the error status of the IO-Link module.
• On: A moderate or major error has occurred.
• Flashing: A minor error has occurred.
• Off: Operating normally
When a major error has been occurred, check RUN LED as well.
Indicates the operating status of each channel in IO-Link mode.
• On: Normal IO-Link communications
• Flashing: IO-Link communication error
• Off: Other than IO-Link mode
Indicates on/off of input or output for each channel in SIO mode
• On: I/O is on.
• Off: I/O is off.
Indicates the error status of each channel in IO-Link mode or SIO mode.
• On: Channel error
• Off: Channels operating normally
Indicates the status of the power supply from the external power supply.
• On: External power supply ON
• Off: External power supply OFF
A switch for the fast link-up function ( Page 30 Function setting switch setting)
*1
1
1 PART NAMES
13