Mitsubishi Electric NZ2GF2S-60IOLD8 User Manual page 157

• When a major error occurs
Current error data 1 to 16
(address: 2B00H to 2BFFH)
Error status flag (RWr0.b10)
Error clear request flag (RWw0.b10)
Remote READY (RWr0.b11)
(1) Occurrence of an error
(2) When a major error has occurred, current error data is not cleared even if an error clear request is issued.
■Remote READY (RWr0.b11)
This signal is used as an interlock condition when the CC-Link IE Field Network master station reads/writes data from/to the
remote register and other areas of the IO-Link module.
When turning on or resetting the module power supply, Remote READY (RWr0.b11) turns on.
Remote READY (RWr0.b11) may turn off while the IO-Link module is operating.
The following shows the conditions under which Remote READY (RWr0.b11) turns off.
• When a moderate or major error occurs (When a moderate error occurs, all causes of errors from Current error data 1 to 16
(address: 2B00H to 2BFFH) will be cleared and Remote READY (RWr0.b11) will remain off until Error clear request flag
(RWw0.b10) is turned on and off.)
• When Error clear request flag (RWw0.b10) is on
• When parameter changes are requested
■Warning status flag (RWr0.b12)
Warning status flag (RWr0.b12) turns on when a minor error occurs.
After five seconds from eliminating the cause of the minor error, the corresponding minor error for Current error data 1 to 16
(address: 2B00H to 2BFFH) is automatically reset to 0000H and Warning status flag (RWr0.b12) turns off.
Current error data 1 to 16
(address: 2B00H to 2BFFH)
Warning status flag (RWr0.b12)
Remote READY (RWr0.b11)
(1) Occurrence of a minor error
(2) The minor error is cleared.
Controlled by the IO-Link module
Controlled by the program
(1)
0000H
ON
ON
OFF
Controlled by the IO-Link module
(1)
0000H Error code
ON
OFF
ON
(Error code)
(2)
ON
OFF
(2)
5 seconds
OFF
Appendix 2 Remote Register
0000H
APPX
155
A