Mitsubishi Electric NZ2GF2S-60IOLD8 User Manual page 102

When the connected device is an SIO device
Provided below is the explanation of the following two cases.
• When replacing a connected SIO device with another SIO device
• When replacing a connected SIO device with an IO-Link device
■Before replacement
Specify the target channel using "Start Device Changeout" of "Command Execution of Slave Station" of the engineering tool.
The following occurs when the target channel is specified.
• CH Input data invalid flag (RX8 to RXF) for the target channel turns on.
Input/output from/to the SIO device turn off.
■After replacing with another SIO device
After replacing with another SIO device, specify the target channel using "Device Changeout Complete" of "Command
Execution of Slave Station" of the engineering tool.
The following occurs after the target channel is specified and the SIO device is replaced with another SIO device properly.
• CH Input data invalid flag (RX8 to RXF) for the target channel turns off.
Even after replacing with another SIO device, input/output from/to the SIO device remains off until the target
channel is specified.
■After replacing with an IO-Link device
After replacing with an IO-Link device, specify the target channel using "Device Changeout Complete" of "Command
Execution of Slave Station" of the engineering tool.
The following occurs after the target channel is specified and the SIO device is replaced with an IO-Link device properly.
• CH Input data invalid flag (RX8 to RXF) for the target channel turns off.
• CH LED of the target channel turns on in green.
• After replacing an SIO device with an IO-Link device, review the program and the parameter settings of the
IO-Link module and IO-Link device as necessary.
• Input/output from/to the IO-Link device remains disabled until the target channel is specified.
7 FUNCTIONS
100
7.8 Device Replacement Function