Setting Switch; Setting Station Number Setting Switches - Mitsubishi Electric NZ2GF2S-60IOLD8 User Manual

5.2

Setting Switch

Setting station number setting switches

Setting procedure
Set the station number using the rotary switches on the front of the IO-Link module. The set value of the station number
becomes valid when the module is powered on. Thus, set the station number while the module power is off.
• The hundreds and tens places of the station number are set with 10.
• The ones place of the station number is set with 1.
To set the station number setting switches, use a flathead screwdriver with a tip width of 3.5mm or less.
Ex.
To set the station number to 115, set the switches as shown below.
Setting range
Set the station number from 1 to 120. Setting the value other than 1 to 120 causes a communication error and the D LINK
LED flashes.
Do not set a station number duplicated with other station numbers. If the station number is duplicated, a
communication error occurs and the D LINK LED does not turn on.
5 INSTALLATION AND WIRING
5.2 Setting Switch
5
29