Mitsubishi Electric NZ2GF2S-60IOLD8 User Manual page 48

5.
Click the [Execute Parameter Processing] button, and the following window is displayed.
6.
Click the [Yes] button.
7.
The parameters are written to the IO-Link module.
8.
Select [Close with Reflecting the Setting] to exit the network configuration setting.
• To read the parameter from the IO-Link module, set "Method selection" to "Read Parameters" and click the
[Execute Parameter Processing] button.
• Set all the items for the parameter. If any blank exists, the parameters cannot be written to the IO-Link
module.
Displayed items
Setting item
Individual Station Parameters
Individual Module Parameters CH1
Individual Module Parameters CH2
Individual Module Parameters CH3

Individual Module Parameters CH7
Individual Module Parameters CH8
6 PARAMETER SETTING
46
6.2 IO-Link Module Parameter Setting
Input Response Time Setting
Output HOLD/CLEAR Setting
Operation Mode
Device Validation Setting
Input OFF Delay Setting
Input Data Mask
Byte Position Swap
Event Retrieval Setting
Bit Slicing Setting
Same as Individual Module Parameters CH1
Notifications
Warnings
Number of Slicings
No.1Bit Offset
No.1Bit Length
No.2Bit Offset
No.2Bit Length

No.15Bit Offset
No.15Bit Length
No.16Bit Offset
No.16Bit Length
Reference
Page 85 Input response time setting
function
Page 94 Output HOLD/CLEAR
setting function
Page 25 Applicable devices
Page 70 IO-Link device validation
function
Page 83 Input OFF delay function
Page 74 Input data masking function
Page 76 Swap function
Page 96 Event Acquisition Function
Page 78 Bit segment function
