Mitsubishi Electric NZ2GF2S-60IOLD8 User Manual page 118

Initial setting description
The following table lists the initial settings of the IO-Link module.
Item
Individual Station
Parameters
Individual Module
Parameters CH1
Individual Module Parameters CH2 to Individual Module Parameters CH7
Individual Module
Parameters CH8
Setting parameters
The setting of parameters is the same as the example of the program to communicate with an IO-Link device. ( Page 109
Setting parameters)
For details on initial parameter settings, refer to the following.
Page 116 Initial setting description
9 PROGRAMMING
116
9.3 Example of Program to Communicate with SIO Device
Input Response Time Setting
Output HOLD/CLEAR Setting
Operation Mode
Device Validation Setting
Input Data Mask
Byte Position Swap
Event Retrieval Setting Notifications
Warnings
Bit Slicing Setting Number of Slicings
No.1 to No.16Bit Offset/
Bit Length
Input OFF Delay Setting
Operation Mode
Device Validation Setting
Input Data Mask
Byte Position Swap
Event Retrieval Setting Notifications
Warnings
Bit Slicing Setting Number of Slicings
No.1 to No.16Bit Offset/
Bit Length
Input OFF Delay Setting
Setting value
5: 10ms
0: CLEAR
4: SIO(Sync Input)Mode
0: Do not validate
0x0000
1: Enable
0: Do not retrieve
1: Retrieve as events
0
0
0: 0
Initial value
7: SIO(Source Output)Mode
0: Do not validate
0x0000
1: Enable
0: Do not retrieve
1: Retrieve as events
0
0
0: 0