Performing Diagnostics; Executing A Command - Qualstar XLS Series Technical & Service Manual

5.5 Performing Diagnostics

4. From the Change Mode section, select Logical Mode.
The Put into Logical Mode confirmation page opens, as shown in
Figure 5-10 Put into Logical Mode confirmation page
5. Press Yes to confirm that you want to put the XLS in logical mode.
5.5 Performing Diagnostics
This section describes how to perform the following Run Diagnostic procedures from the
Service portlet:
• Execute Command (see
• Audit Library (see
• View SCSI Log (see
• Service Utilities (see
Note: For instructions for shutting down the library, see
5.5.1

Executing a Command

The Execute Command option was designed for Qualstar Technical
Support and Engineering use. To prevent operational problems with
the library, be sure to contact Qualstar Technical Support before
attempting to execute any diagnostic commands on the XLS.
5-12
Section 5.5.1)
Section 5.5.2 on page
Section 5.5.3 on page
Section 5.5.4 on page 5-15
CAUTION
Figure
5-13)
5-14)
Section 6.2 on page
5-10.
6-1.
501610 Rev. 07-01-19