Drive Filler Assembly Removal Procedure; Drive Filler Assembly Replacement; Tape Drive Assemblies - Qualstar RLS-8350 Technical & Service Manual

7.12.1 Drive Filler Assembly Removal Procedure

Use a No. 2 Phillips screwdriver to remove the screw that secures the Drive Fill-
1.
er Assembly to the rear of the RLS.
Slide the Drive Filler Assembly out of the RLS.
2.

7.12.2 Drive Filler Assembly Replacement

This procedure assumes that the Drive Filler Assembly was removed in Section
7.12.1.
Align the Drive Filler Assembly with its opening and push it into the rear of the
1.
library until you feel it stop.
Use a No. 2 Phillips screwdriver to replace and tighten the two screws that se-
2.
cures the Drive Filler Assembly to the rear of the RLS.

7.13 Tape Drive Assemblies

P/N 510903-01-6
P/N 510903-02-0
P/N 510903-04-0
P/N 510903-05-7
P/N 510903-06-5
P/N 510903-08-1
P/N 510903-59-4
P/N 510903-60-2
P/N 510903-61-0
P/N 510903-70-1
P/N 5109023-71-9
P/N 510903-72-7
Tools Required:
511010 Rev. 07-01-19
Tape Drive LTO-5 SAS
Tape Drive LTO-5 FC
Tape Drive LTO-5 FC Dual Port
Tape Drive LTO-6 SAS
Tape Drive LTO-6 FC
Tape Drive LTO-6 FC Dual Port
Tape Drive LTO-7 SAS
Tape Drive LTO-7 FC
Tape Drive LTO-7 FC Dual Port
Tape Drive LTO-8 SAS
Tape Drive LTO-8 FC
Tape Drive LTO-8 FC Dual Port
Field–Replaceable Units (FRUs) 7-17