Table of Contents
Advertisement
Chapter 25
| LLDP Commands
show lldp config
notifications include information about state changes in the LLDP MIB (IEEE
802.1AB), or organization-specific LLDP-EXT-DOT1 and LLDP-EXT-DOT3 MIBs.
◆
SNMP trap destinations are defined using the
◆
Information about additional changes in LLDP neighbors that occur between
SNMP notifications is not transmitted. Only state changes that exist at the time
of a trap notification are included in the transmission. An SNMP agent should
therefore periodically check the value of lldpStatsRemTableLastChangeTime to
detect any lldpRemTablesChange notification-events missed due to throttling
or transmission loss.
Example
Console(config)#interface ethernet 1/1
Console(config-if)#lldp notification
Console(config-if)#
This command shows LLDP configuration settings for all ports.
Syntax
show lldp config [detail interface]
detail - Shows configuration summary.
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-28/52)
port-channel channel-id (Range: 1-26)
Command Mode
Privileged Exec
Example
The following example shows all basic LLDP parameters are enabled on Port 1.
Console#show lldp config
LLDP Global Configuation
LLDP Enabled
LLDP Transmit Interval
LLDP Hold Time Multiplier
LLDP Delay Interval
LLDP Re-initialization Delay : 2 sec.
LLDP Notification Interval
LLDP MED Fast Start Count
: Yes
: 30 sec.
: 4
: 2 sec.
: 5 sec.
: 4
– 764 –
snmp-server host
command.
Hide quick links:
Advertisement
Table of Contents
