Analog Input Signal Parameters - IDK MSD-6203 User Manual

MSD-62 Series User's Guide

9.7.3 Analog input signal parameters

Menu Top→INPUT SETTING→ANALOG INPUT TYPE
Setting for Each input channel, each input signal, analog input only
Setting value
・AUTO : Automatic [Default]
・RGB
: Analog RGB
・YPbPr : Analog YPbPr
You can set the type of input analog video signal.
If you select "AUTO", the type of input signals are detected automatically. In cases where the detection fails
and video is not output correctly, set the input type manually. With "AUTO", the automatic detection of
S-Video may fail. If both composite video and S-Video are input at the same time, select "VIDEO AUTO"; if
only S-Video is input, select "Y/C".
This menu is available if "9.7.5 Selecting signal of DVI input connector" is set to "ANALOG".
Note:
For video from a monochrome camera or VHS tape with in poor condition or the like, automatic detection may
fail. Under these circumstances, select "VIDEO AUTO", "VIDEO" or "Y/C".
80
・VIDEO AUTO
: Video (Automatic)
・VIDEO
: Composite video
・Y/C
: S video
【See: 9.7.5 Selecting signal of DVI input connector】