Signal Type Of Analog Input - IDK MSD-72 Series User Manual

9.5.3 Signal type of analog input

Menu Top→INPUT SETTING→ANALOG INPUT TYPE
Setting for Each input channel, each input signal (only analog input)
Setting value
・AUTO : Automatic [Default]
・RGB
: Analog RGB
・YPbPr : Analog YPbPr
You can set the signal type that is input from the DVI-I input connector.
If you select "AUTO", the type of input signal is detected automatically. In cases where the detection fails and
video is not output correctly, set the input type manually. With "AUTO", the automatic detection of S-Video
may fail. If both composite video and S-Video are input at the same time, select "VIDEO AUTO"; if only
S-Video is input, select "Y/C".
This menu is available only if analog signal is input to IN8 or IN9.
Note:
For video of a monochrome camera or VHS tape with a bad recording condition or the like, automatic
detection may fail. In these cases, select "VIDEO AUTO", "VIDEO" or "Y/C".
・VIDEO AUTO : Video automatic
・VIDEO
: Composite video
・Y/C
: S video
63
MSD-72 Series User's Guide