Table of Contents
Advertisement
MSD-72 Series User's Guide
9.3.4 Aspect ratio control
Menu
Top→OUTPUT TIMING→ASPECT PROCESS
Setting for
Each input channel, each input signal
Setting value L-BOX/S-PANEL : letter box/side panel [Default]
S-CUT/TB-CUT : Side cut/top bottom cut
You can get how to restore aspect ratio.
9.3.5 Overscan
Menu
Top→OUTPUT TIMING→INPUT OVER SCAN
Setting for
Each input channel, each input signal
Setting value 100% to 115%
[Default] NTSC / PAL / SDTV: 105%; HDTV / PC: 100%
You can set enlarged display of input video.
Note:
This menu can be set up to 115%, but if the dot clock of input signal exceeds 170 MHz, it is treated as 100%.
In this case, "*" is displayed on the VFD screen.
9.3.6 Display position
Menu
Top→OUTPUT TIMING→INPUT POSITION (Input side) / OUTPUT POSITION (Output side)
Setting for
Input side
Output side
Setting value
Input side:
Horizontal position
Vertical position
Output side:
Horizontal position
Vertical position
You can set the position where input video is displayed.
Note:
If the resolutions of each output are not the same, the resolution of OUT1 will be the standard.
54
Input signal
L-BOX/S-PANEL
16:9 input video is output to
Letter box
a 4:3 sink device.
4:3 input video is output to a
Side panel
16:9 sink device.
[Figure 9.6] Restoring aspect ratio
: Each input channel, each input signal
: Each output channel
(-Horizontal input size
(-Vertical input size
(-Horizontal output size to
(-Vertical output size
Output signal
S-CUT/TB-CUT
Side cut
Top/bottom cut
to
+Horizontal output resolution
to
+Vertical output resolution
+Horizontal output resolution
to
+Vertical output resolution
[Default] 0)
[Default] 0)
[Default] 0)
[Default] 0)
Advertisement
Table of Contents
