Alcatel 5620 Troubleshooting Manual page 63

Alarm name, ID, type, and default
probable cause
Name: Poller Problem
ID: 31
Type: Communications Alarm
Probable cause: Resync Failed
Name: Redundancy Switchover
ID: 181
Type: Equipment Alarm
Probable cause: Redundancy Switchover
Name: SNMP Authentication Failure
ID: 176
Type: Authentication Alarm
Probable cause: Auth Failure
Name: SNMP Daemon Problem
ID: 161
Type: Communication Alarm
Probable cause: SNMP Daemon Error
Name: SNMP Trap Dropped
ID: 179
Type: Communication Alarm
Probable cause: SNMP Daemon Overloaded
Name: Standby CPM Management
Connection Down
ID: 140
Type: Communications Alarm
Probable cause: Management Connection
Down
Name: Standby Host Status
ID: 183
Type: Communication Alarm
Probable cause: System Failed
Name: Trap Destination Misconfigured
ID: 33
Type: Configuration Alarm
Probable cause: Trap Destination
Misconfigured
(3 of 4)
Alcatel 5620 Service Aware Manager, Release 2.1 R2
May 2005 95-5887-01-00-B
Default Severity, object type
Severity: warning
Object type: Network Element
Domain: netw
Severity: warning
Object type: Network Element
Domain: netw
Severity: warning
Object type: Network Element
Domain: netw
Severity: warning
Object type: Network Element
Domain: netw
Severity: warning
Object type: Network Element
Domain: netw
Severity: critical
Object type: Node Discovery Control
Domain: netw
Severity: Critical
Object type: Nms System
Domain: netw
Severity: major
Object type: Network Element
Domain: netw
3 — Troubleshooting network alarms
Additional information
Unable to poll a network object.
Possible causes include: intermittent
or no IP connectivity to the network
object, incorrect SNMP security
parameters, or SNMP is disabled on
the router.
Non-5620 SAM related polling
problems may include physical
cabling from the NMS domain to the
managed devcies, and NIC card
issues
—
—
—
—
—
—
The SNMP trap destination
configured on the router is not
pointing to 5620 SAM.
3-27