Alcatel 5620 Troubleshooting Manual page 58

3 — Troubleshooting network alarms
Alarm name, ID, type, and default
probable cause
Name: Hardware Redundancy
ID: 147
Type: Equipment Alarm
Probable cause: Primary CPM Failure
Name: Link Down
ID: 12
Type: Communications Alarm
Probable cause: Port Link Problem
Name: Software Failure
ID: 149
Type: Software Alarm
Probable cause: Load Failed
Name: Temperature Threshold Crossed
ID: 7
Type: Environmental Alarm
Probable cause: Equipment Overheated
(2 of 2)
Alarm name, ID, type, and default
probable cause
Name: Deployment Failure
ID: 13
Type: Deployment Failure
Probable cause: Failed To Modify Network
Resource
Name: Threshold Crossing Alarm
ID: 14
Type: Threshold Crossed
Probable cause: Threshold Crossed
3-22
Default Severity, object type
Severity: major
Object type: Control Processor
Domain: equipment
Severity: major
Object type: Equipment
Domain: equipment
Severity: critical
Object type: Replaceable Unit
Domain: equipment
Severity: major
Object type: Environment
Domain: equipment
Table 3-5 Generic alarms
Default Severity, object type
Severity: minor
Object type: Generic Object
Domain: generic
Severity: warning
Object type: Generic Object
Domain: generic
Alcatel 5620 Service Aware Manager, Release 2.1 R2
Additional information
—
—
This alarm is generated when the
CPM fails to load the software from
the specified location.
To display the temperature
threshold, choose Equipment
Manager->Cards tab->Environment.
Additional information
Unable to create, modify, or delete a
network object because there is
intermittent or no IP connectivity to
the network object, SNMP security
parameters are incorrect, or SNMP
is disabled on the router.
Check the deployment tab using the
5620 SAM client GUI, as described
in Procedure 8-4.
—
May 2005 95-5887-01-00-B