Procedure 10-4 Problem: The Oracle Database Is Not Performing As Expected On A Solaris Platform - Alcatel 5620 Troubleshooting Manual

3
4
5
6
To retrieve the changes since the database was saved and restored, you can:
Procedure 10-4 Problem: The Oracle database is not performing as
expected on a Solaris platform
1
2
Alcatel 5620 Service Aware Manager, Release 2.1 R2
May 2005 95-5887-01-00-B
Specify the backup directory where the backed up version of the database can be
found.
The path to the backup directory on the restoration workstation must match the
backup directory on the workstation where the backup is made.
Specify whether to create a copy of the backed up database. When the backup
database is restored, Oracle modifies the backup and it cannot be reused.
Specify any additional parameters, as listed in the 5620 SAM Installation and
Upgrade Guide.
For Solaris installations, run the following from the install
directory/config/databasename directory:
solaris_root.sh ↵
This script enables automatic database startup and shutdown at reboot.
•
wait for the normally scheduled polling interval to retrieve the latest changes to
the MIB
•
resync with the network
•
rediscover portions of the network as required
Warning — Performing any database modifications using the Oracle
database or tablespace tools can cause irreparable harm to the database
and your network management data. Performing such modifications can
void your Alcatel warranty and support agreements. Contact your Alcatel
technical support representative to help you troubleshoot your database.
Ensure that the following Solaris kernel settings are correct in the /etc/system file:
set semsys:seminfo_semmni=100
set semsys:seminfo_semmns=1024
set semsys:seminfo_semmsl=256
set semsys:seminfo_semmnu=400
set semsys:seminfo_semume=200
set shmsys:shminfo_shmmax=value_of_RAM
set shmsys:shminfo_shmmin=1
set shmsys:shminfo_shmmni=100
set shmsys:shminfo_shmseg=10
where value_of_RAM is at least half of physical RAM size for the workstation platform, for example
1073741824 for 2Gbytes of RAM
Ensure the shmmax value in the system file does not exceed available physical
RAM.
10 — Troubleshooting the 5620 SAM database
10-5