Ptp Vlan - Cisco nexus 3000 series Command Reference Manual

Chapter System Management Commands
S e n d c o m m e n t s t o n e x u s 3 k - d o c f e e d b a c k @ c i s c o . c o m

ptp vlan

To configure a VLAN to generate the Precision Time Protocol (PTP) messages for Layer 2 interfaces,
use the ptp vlan command. To remove the PTP VLAN configuration from an interface, use the no form
of this command.
Syntax Description
vlan-number
Command Default
1
Command Modes Interface configuration mode
Command History Release
5.0(3)U2(2)
Usage Guidelines Make sure that you have globally enabled PTP on the switch and configured the source IP address for
PTP communication.
Use this command only on Layer 2 Ethernet interfaces (1 Gigabit, 10-Gigabit, 40-Gigabit) or
port-channel members.
By default, VLAN 1 is used to generate the PTP messages on an interface. You must explicitly configure
the following VLANs to generate PTP messages on interfaces:
•
•
This command does not require a license.
Examples This example shows how to configure the PTP VLAN value on an interface:
switch# configure terminal
switch(config)# interface ethernet 1/5
switch(config-if)# ptp vlan 9
switch(config-if)#
This example shows how to remove the PTP VLAN value from an interface:
switch# configure terminal
switch(config)# interface ethernet 1/5
switch(config-if)# no vlan 9
switch(config-if)#
OL-29557-04
ptp vlan vlan-number
no ptp vlan vlan-number
VLAN number. The range is from 1 to 4094.
Modification
This command was introduced.
nondefault access VLANs on an access port
nondefault native VLANs on a trunk port
Cisco Nexus 3000 Series NX-OS System Management Command Reference
ptp vlan
-SM-169