Cisco nexus 3000 series Command Reference Manual page 255

Chapter System Management Commands
show monitor session
S e n d c o m m e n t s t o n e x u s 3 k - d o c f e e d b a c k @ c i s c o . c o m
filter VLANs : filter not specified
rx :
source fwd drops :
egress-intf : Po10switch
switch#
This example shows the information displayed beginning with release 7.0(3)I2(1).
switch# show monitor session 1
session 1
---------------
type : local
state : down (Session admin shut)
acl-name : acl-name not specified
source intf :
rx :
tx :
both :
source VLANs :
rx : 5
tx :
both :
filter VLANs : filter not specified
source fwd drops :
destination ports :
switch#
This example shows how to display a range of SPAN sessions:
switch# show monitor session range 1-4
This example shows how to display the information about an ERSPAN session on a switch that runs
Cisco NX-OS Release 5.0(3)U2(2):
switch# show monitor session 1
session 1
---------------
type : erspan-source
state : up
vrf-name : default
destination-ip : 90.1.1.1
ip-ttl : 255
ip-dscp : 0
acl-name : acl-name not specified
origin-ip : 200.1.1.1 (global)
source intf :
rx : Eth1/9
tx : Eth1/9
both : Eth1/9
source VLANs :
filter VLANs : filter not specified
rx :
source fwd drops :
egress-intf : Po10switch
switch#
Cisco Nexus 3000 Series NX-OS System Management Command Reference
-SM-231
OL-29557-04