Logging Module - Cisco nexus 3000 series Command Reference Manual

Chapter System Management Commands
S e n d c o m m e n t s t o n e x u s 3 k - d o c f e e d b a c k @ c i s c o . c o m

logging module

To enable module log messages, use the logging module command. To disable module log messages,
use the no form of this command.
Syntax Description
severity-level
Command Default None
Command Modes
Global configuration mode
Command History Release
5.0(3)U1(1)
Usage Guidelines Set a specified severity level or use the default.
Examples
This example shows how to enable module log messages:
switch# configure terminal
switch(config)# logging module
switch(config)#
Related Commands Command
show logging module
OL-29557-04
logging module [severity-level]
no logging module
(Optional) Number of the desired severity level at which messages should be
logged. Messages at or numerically lower than the specified level are logged.
Severity levels are as follows:
•
•
•
•
•
•
•
•
Modification
This command was introduced.
Description
Displays the module logging status.
0—emergency: System unusable
1—alert: Immediate action needed
2—critical: Critical condition
3—error: Error condition
4—warning: Warning condition
5—notification: Normal but significant condition—default level
6—informational: Informational message only
7—debugging: Appears during debugging only
Cisco Nexus 3000 Series NX-OS System Management Command Reference
logging module
-SM-111