Ptp Source - Cisco nexus 3000 series Command Reference Manual

Chapter System Management Commands
S e n d c o m m e n t s t o n e x u s 3 k - d o c f e e d b a c k @ c i s c o . c o m

ptp source

To configure the global source for all the Precision Time Protocol (PTP) packets, use the ptp source
command. To remove the global source for PTP packets, use the no form of this command.
Syntax Description
ip_address
vrf
vrf-name
management
Command Default None
Command Modes
Global configuration mode
Command History Release
5.0(3)U2(2)
Usage Guidelines
This command does not require a license.
Examples
This example shows how to configure the global source for all the PTP packets:
switch# configure terminal
switch(config)# ptp source 192.0.1.1
switch(config)#
This example shows how to remove the global source configuration for all the PTP packets:
switch# configure terminal
switch(config)# no ptp source 192.0.1.1
switch(config)#
Related Commands Command
feature ptp
ptp domain
ptp priority1
ptp priority2
OL-29557-04
ptp source ip_address [vrf {vrf-name | management]
no ptp source ip_address [vrf {vrf-name | management]
IPv4 address of the source.
Specifies the virtual routing and forwarding (VRF) instance.
Name of the VRF. The name can be a maximum of 32 alphanumeric
characters and is case sensitive.
Specifies the management VRF.
Modification
This command was introduced.
Description
Enables or disables PTP on the device.
Configures the domain number to use for this clock.
Configures the priority1 value to use when advertising this clock.
Configures the priority2 value to use when advertising this clock.
Cisco Nexus 3000 Series NX-OS System Management Command Reference
ptp source
-SM-165