Event Fanabsent - Cisco nexus 3000 series Command Reference Manual

Chapter System Management Commands
S e n d c o m m e n t s t o n e x u s 3 k - d o c f e e d b a c k @ c i s c o . c o m

event fanabsent

To specify an event criteria for an Embedded Event Manager (EEM) applet that is run on the basis of a
fan absent event, use the event fanabsent command. To remove the fan absent event criteria, use the no
form of this command.
Syntax Description
fan number
time interval
Defaults
None
Command Modes Embedded event manager configuration mode
Command History Release
5.0(3)U3(1)
Usage Guidelines
This command does not require a license.
Examples This example shows how to specify that an EEM applet runs when a fan absent event occurs:
switch# configure terminal
switch(config)# event manager applet absent-applet
switch(config-applet)# event fanabsent time 600
switch(config-applet)#
OL-29557-04
event fanabsent [fan number] time interval
no event fanabsent [fan number] time interval
(Optional) Specifies a fan number to monitor for a fan absent event. The range is
from 1 to 1.
Specifies the time interval in seconds within which the fan can stay absent. The
range is from 10 to 64000.
Modification
This command was introduced.
Cisco Nexus 3000 Series NX-OS System Management Command Reference
event fanabsent
-SM-57