Cisco nexus 3000 series Command Reference Manual page 181

Chapter System Management Commands
S e n d c o m m e n t s t o n e x u s 3 k - d o c f e e d b a c k @ c i s c o . c o m
ptp
To enable the Precision Time Protocol (PTP) on an interface, use the ptp command. To disable PTP on
an interface, use the no form of this command.
Syntax Description
This command has no arguments or keywords.
Command Default None
Command Modes Interface configuration mode
Command History Release
5.0(3)U2(2)
Usage Guidelines This command does not require a license.
Examples This example shows how to enable PTP on an interface:
switch# configure terminal
switch(config)# interface ethernet 1/5
switch(config-if)# ptp
switch(config-if)#
This example shows how to disable PTP on an interface:
switch# configure terminal
switch(config)# interface ethernet 1/5
switch(config-if)# no ptp
switch(config-if)#
Related Commands Command
feature ptp
ptp delay-request
minimum interval
ptp source
ptp sync interval
ptp vlan
OL-29557-04
ptp
no ptp
Modification
This command was introduced.
Description
Enables or disables PTP on the device.
Configures the minimum interval allowed between PTP delay-request
messages when the port is in the master state.
Configures the source IP address for all PTP packets.
Configures the interval between PTP synchronization messages on an
interface.
Configures the PTP VLAN value on an interface.
Cisco Nexus 3000 Series NX-OS System Management Command Reference
ptp
-SM-157