Logging Monitor - Cisco nexus 3000 series Command Reference Manual

logging monitor

S e n d c o m m e n t s t o n e x u s 3 k - d o c f e e d b a c k @ c i s c o . c o m
logging monitor
To enable the device to log messages to the monitor (terminal line), use the logging monitor command.
To disable monitor log messages, use the no form of this command.
Syntax Description
severity-level
Command Default None
Command Modes
Global configuration mode
Command History Release
5.0(3)U1(1)
Usage Guidelines This configuration applies to Telnet and Secure Shell (SSH) sessions.
Examples
This example shows how to enable monitor log messages:
switch# configure terminal
switch(config)# logging monitor
switch(config)#
Related Commands Command
show logging monitor
Cisco Nexus 3000 Series NX-OS System Management Command Reference
-SM-112
logging monitor [severity-level]
no logging monitor
(Optional) Number of the desired severity level at which messages should be
logged. Messages at or numerically lower than the specified level are logged.
Severity levels are as follows:
•
•
•
•
•
•
•
•
Modification
This command was introduced.
Description
Displays the status of monitor logging.
0—emergency: System unusable
1—alert: Immediate action needed
2—critical: Critical condition—default level
3—error: Error condition
4—warning: Warning condition
5—notification: Normal but significant condition
6—informational: Informational message only
7—debugging: Appears during debugging only
Chapter System Management Commands
OL-29557-04