Destination Interface (Erspan) - Cisco nexus 3000 series Command Reference Manual

Chapter System Management Commands
S e n d c o m m e n t s t o n e x u s 3 k - d o c f e e d b a c k @ c i s c o . c o m

destination interface (ERSPAN)

To configure interfaces for an Encapsulated Remote Switched Port Analyzer (ERSPAN) destination, use
the destination interface command. To remove the interfaces from an ERSPAN session, use the no form
of this command.
Syntax Description
ethernet
slot/port
Command Default None
Command Modes ERSPAN destination configuration mode
Command History Release
5.0(3)U2(2)
Usage Guidelines The destination port should be previously configured as a switchport monitor.
This command does not require a license.
Examples This example shows how to configure an ERSPAN destination interface:
switch# configure terminal
switch(config)# monitor session 1 type erspan-destination
switch(config-erspan-dst)# destination interface ethernet 1/5
switch(config-erspan-dst)#
Related Commands Command
monitor session
show monitor session
show running-config
monitor
source (SPAN session) Configures a source SPAN port.
source (ERSPAN
session)
OL-29557-04
destination interface ethernet slot/port
no destination interface ethernet slot/port
Specifies the Ethernet interface.
Ethernet interface slot number and port number. The slot number is from 1
to 255, and the port number is from 1 to 128.
Modification
This command was introduced.
Description
Creates a new SPAN session configuration.
Displays SPAN session configuration information.
Displays the running configuration information of a SPAN session.
Configures a source VLAN interface.
Cisco Nexus 3000 Series NX-OS System Management Command Reference
destination interface (ERSPAN)
-SM-45