Clock Protocol - Cisco nexus 3000 series Command Reference Manual

clock protocol

S e n d c o m m e n t s t o n e x u s 3 k - d o c f e e d b a c k @ c i s c o . c o m
clock protocol
To set the synchronization protocol for the clock to a protocol, use the clock protocol command. To
remove the clock protocol, use the no form of this command.
Note
Syntax Description none
ntp
ptp
Command Default None
Command Modes Global configuration mode
Command History Release
5.0(3)U2(2)
7.0(3)I2(1)
Usage Guidelines This command does not require a license.
Examples
This example shows how to set the synchronization protocol for the clock to PTP:
switch# configure terminal
switch(config)# clock protocol ptp
switch(config)#
Related Commands Command
feature ptp
show ptp clock
show running-config
ptp
Cisco Nexus 3000 Series NX-OS System Management Command Reference
-SM-36
Beginning in Release 7.0(3)I2(1), this command will not set the clock. To change the clock
manually, see the Cisco Nexus 3000 Series NX-OS Fundamentals Configuration Guide.
clock protocol {none | ntp | ptp}
no clock protocol {none | ntp | ptp}
Specifies that the clock can be set manually.
Specifies that the clock be set to the Network Time Protocol (NTP).
Specifies that the clock be set to the Precision Time Protocol (PTP).
Modification
This command was introduced.
This command will not set the clock
Description
Enables PTP on the switch.
Displays the PTP clock information.
Displays the PTP running system configuration information.
Chapter System Management Commands
OL-29557-04