Logging Server - Cisco nexus 3000 series Command Reference Manual

Chapter System Management Commands
S e n d c o m m e n t s t o n e x u s 3 k - d o c f e e d b a c k @ c i s c o . c o m

logging server

To configure a remote syslog server at the specified hostname or IPv4/IPv6 address, use the logging
server command. To disable the remote syslog server, use the no form of this command.
Syntax Description
host
severity-level
facility facility
vrf vrf_name
management
Command Default The default outgoing facility is local7.
The default VRF is management.
Command Modes
Global configuration mode
Command History Release
5.0(3)U1(1)
OL-29557-04
logging server host [severity-level] [facility facility | use-vrf {vrf_name | management}]
no logging server host [severity-level] [facility facility | use-vrf {vrf_name | management}]
Hostname or IPv4/IPv6 address of the remote syslog server.
(Optional) Number of the desired severity level at which messages should be
logged. Messages at or numerically lower than the specified level are logged.
Severity levels are as follows:
•
•
•
•
•
•
•
•
(Optional) Specifies the outgoing facility. The facility can be one of the
following: auth, authpriv, cron, daemon, ftp, kernel, local0, local1,
local2, local3, local4, local5, local6, local7, lpr, mail, news, syslog, user,
uucp
The default outgoing facility is local7.
(Optional) Specifies the virtual routing and forwarding (VRF) to be used in
the remote server. The name can be a maximum of 32 alphanumeric
characters.
Specifies the management VRF. This is the default VRF.
Modification
This command was introduced.
0—emergency: System unusable
1—alert: Immediate action needed
2—critical: Critical condition—default level
3—error: Error condition
4—warning: Warning condition
5—notification: Normal but significant condition
6—informational: Informational message only
7—debugging: Appears during debugging only
Cisco Nexus 3000 Series NX-OS System Management Command Reference
logging server
-SM-113