Ntp Peer - Cisco nexus 3000 series Command Reference Manual

ntp peer

S e n d c o m m e n t s t o n e x u s 3 k - d o c f e e d b a c k @ c i s c o . c o m
ntp peer
To configure a device as a Network Time Protocol (NTP) peer, use the ntp peer command. To remove
the device as an NTP peer, use the no form of this command.
Syntax Description
ip-address
ipv6-address
dns-name
Defaults None
Command Modes
Global configuration mode (config)
Command History Release
6.0(2)U(2)1
Usage Guidelines You can configure multiple peer associations.
This command does not require a license.
Examples
This example shows how to configure an NTP peer:
switch(config)# configure terminal
switch(config)# ntp peer 190.0.2.1
switch(config)#
This example shows how to remove an NTP peer:
switch# configure terminal
switch(config)# no ntp peer 190.0.2.1
switch(config)#
Related Commands Command
ntp server
show ntp peers
show ntp peer-status
Cisco Nexus 3000 Series NX-OS System Management Command Reference
-SM-148
ntp peer {ip-address | ipv6-address | dns-name}
no ntp peer {ip-address | ipv6-address | dns-name}
IPv4 address.
IPv6 address.
Domain Name Server (DNS) name.
Modification
This command was introduced.
Description
Configures an NTP server.
Displays all the NTP peers.
Displays the status for all the server/peers.
Chapter System Management Commands
OL-29557-04