Ptp Announce - Cisco nexus 3000 series Command Reference Manual

ptp announce

S e n d c o m m e n t s t o n e x u s 3 k - d o c f e e d b a c k @ c i s c o . c o m
ptp announce
To configure the interval between Precision Time Protocol (PTP) announce messages on an interface or
the number of PTP intervals before a timeout occurs on an interface, use the ptp announce command.
To remove the interval configuration for PTP messages, use the no form of this command.
Syntax Description
interval
seconds
timeout
count
Command Default
interval 1
timeout 3
Command Modes Interface configuration mode
Command History Release
7.0(3)|2(1)
5.0(3)U2(2)
Usage Guidelines Make sure that you have globally enabled PTP on the switch and configured the source IP address for
PTP communication.
This command does not require a license.
Examples This example shows how to configure the interval between PTP announce messages on an interface:
switch# configure terminal
switch(config)# interface ethernet 1/5
switch(config-if)# ptp announce interval 1
switch(config-if)#
This example shows how to remove the interval configuration for PTP messages from an interface:
switch# configure terminal
switch(config)# interface ethernet 1/5
switch(config-if)# no ptp announce interval 1
switch(config-if)#
Cisco Nexus 3000 Series NX-OS System Management Command Reference
-SM-158
ptp announce {interval seconds | timeout count}
no ptp announce {interval seconds | timeout count}
Specifies the interval between Precision Time Protocol (PTP) announce
messages on an interface.
Log seconds. The range is from 0 to 4.
Specifies the number of PTP intervals before a timeout occurs on an
interface.
Timeout count. The range is from 2 to 10. Beginning in Release 7.0(3)|2(1),
the value is 2 to 4.
Modification
The count changed to 2 to 4.
This command was introduced.
Chapter System Management Commands
OL-29557-04