Logging Console - Cisco nexus 3000 series Command Reference Manual

logging console

S e n d c o m m e n t s t o n e x u s 3 k - d o c f e e d b a c k @ c i s c o . c o m
logging console
To enable logging messages to the console session, use the logging console command. To disable
logging messages to the console session, use the no form of this command.
Syntax Description
severity-level
Command Default None
Command Modes
Global configuration mode
Command History Release
5.0(3)U1(1)
Examples This example shows how to enable logging messages with a severity level of 4 (warning) or higher to
the console session:
switch# configure terminal
switch(config)# logging console 4
switch(config)#
Related Commands Command
show logging console
Cisco Nexus 3000 Series NX-OS System Management Command Reference
-SM-100
logging console [severity-level]
no logging console
(Optional) Number of the desired severity level at which messages should be
logged. Messages at or numerically lower than the specified level are logged.
Severity levels are as follows:
•
•
•
•
•
•
•
•
Modification
This command was introduced.
Description
Displays the console logging configuration.
0—emergency: System unusable
1—alert: Immediate action needed
2—critical: Critical condition—default level
3—error: Error condition
4—warning: Warning condition
5—notification: Normal but significant condition
6—informational: Informational message only
7—debugging: Appears during debugging only
Chapter System Management Commands
OL-29557-04