Show Monitor Session - Cisco nexus 3000 series Command Reference Manual

show monitor session

S e n d c o m m e n t s t o n e x u s 3 k - d o c f e e d b a c k @ c i s c o . c o m
show monitor session
To display information about the Switched Port Analyzer (SPAN) or Encapsulated Remote Switched
Port Analyzer (ERSPAN) sessions, use the show monitor session command.
Note
Syntax Description
session
all
brief
range range
Command Default
None
Command Modes EXEC mode
Command History Release
5.0(3)U1(1)
5.0(3)U2(2)
6.0(2)U5(1)
7.0(3)I2(1)
Examples This example shows how to display information about SPAN session 1:
switch# show monitor session 1
session 1
---------------
type : erspan-source
state : up
vrf-name : default
destination-ip : 90.1.1.1
ip-ttl : 255
ip-dscp : 0
acl-name : acl-name not specified
origin-ip : 200.1.1.1 (global)
source intf :
rx : Eth1/9
tx : Eth1/9
both : Eth1/9
source VLANs :
Cisco Nexus 3000 Series NX-OS System Management Command Reference
-SM-230
Beginning with Release 7.0(3)I2(1), the rx, tx, and both options are displayed for the source
VLANs and an option for the filter VLANs is not displayed. Also, the number of TCAM entries
available for ACL SPAN has been reduced by 6 entries.
show monitor session [session | all [brief] | range range [brief]]
(Optional) Number of the session. The range is from 1 to 18.
(Optional) Displays all sessions.
(Optional) Displays a brief summary of the information.
(Optional) Displays a range of sessions. The range is from 1 to 18.
Modification
This command was introduced.
Support for ERSPAN was added.
The egress interface information is added for the ERSPAN source session.
This command displays rx, tx, and both options for the source VLANs and
does not display an option for the filter VLANs
Chapter System Management Commands
OL-29557-04