Action Reload - Cisco nexus 3000 series Command Reference Manual

action policy-default
S e n d c o m m e n t s t o n e x u s 3 k - d o c f e e d b a c k @ c i s c o . c o m
action policy-default
To enable the default action of the policy being overridden, use the action policy-default command. To
remove the default action, use the no form of this command.
Syntax Description
label num1 [.num2] Unique identifier that can be any string value. Actions are sorted and run in an
Defaults
None
Command Modes Embedded event manager configuration mode
Command History Release
5.0(3)U3(1)
Usage Guidelines
This command does not require a license.
Examples This example shows how to enable the default action of a policy being overridden when an EEM applet
is triggered:
switch# configure terminal
switch(config)# event manager applet default-applet
switch(config-applet)# action 1.0 policy-default
switch(config-applet)#
Related Commands Command
action cli
action counter
action event-default

action reload

Cisco Nexus 3000 Series NX-OS System Management Command Reference
-SM-10
action label num1 [.num2] policy-default
no action label num1 [.num2] policy-default
ascending alphanumeric sequence using the label as the sort key. The range for
num1 is from 1 to 16 and the range for num2 is from 0 to 9.
Modification
This command was introduced.
Description
Configures a virtual shell (VSH) command string to be executed when an
Embedded Event Manager (EEM) applet is triggered.
set or modify a named counter when an Embedded Event Manager (EEM)
applet is triggered.
Specifies that the default action for the event is to be performed when an
Embedded Event Manager (EEM) applet is triggered.
Specifies the action of reloading the Cisco Nexus 3000 Series software
when an Embedded Event Manager (EEM) applet is triggered.
Chapter System Management Commands
OL-29557-04