Switching-Mode Store-Forward - Cisco nexus 3000 series Command Reference Manual

switching-mode store-forward

S e n d c o m m e n t s t o n e x u s 3 k - d o c f e e d b a c k @ c i s c o . c o m
switching-mode store-forward
To enable store-and-forward switching mode on a Cisco NX-OS device, use the switching-mode
store-forward command. To reenable cut-through switching on a Cisco NX-OS device, use the no form
of this command.
Syntax Description
This command has no arguments or keywords.
Defaults
Disabled
Command Modes Global configuration mode
Command History Release
5.0(3)U3(1)
Usage Guidelines
Enabling store-and-forward switching mode might impact your port-to-port switching latency.
This command does not require a license.
Examples This example shows how to enable store-and-forward switching mode on a Cisco NX-OS device:
switch# configure terminal
switch(config)# switching-mode store-forward
switch(config)#
This example shows how to reenable cut-through switching mode on a Cisco NX-OS device:
switch(config)# no switching-mode store-forward
switch(config)#
Cisco Nexus 3000 Series NX-OS System Management Command Reference
-SM-324
switching-mode store-forward
no switching-mode store-forward
Modification
This command was introduced.
Chapter System Management Commands
OL-29557-04