Check the idle screw underneath the throttle body to see if the throttle arm is hitting it. If it is not, either
loosen the ball stud retainer set screw and readjust the cable or, bend the small tab behind the accelerator
pedal until the idle screw hits the throttle arm. You will notice a fairly high idle later when the car starts
if the throttle is held open.
Carbureted applications
Attach the cable sheath to your cable mount on the engine.
If necessary, attach the supplied ball stud to the carburetor in the appropriate location. Refer to the
carburetor instructions for placement.
Attach the ball stud retainer to the ball stud.
Using a pair of wire cutters, cut the barrel fitting off the cable.
231
www.factoryfive.com
508-291-3443