Using Dial-Up Networking With A Ppp Serial Port Console - Avaya 580 User Manual

Chapter 2

Using Dial-Up Networking with a PPP Serial Port Console

2-34
24. Select OK to close the TCP/IP window.
25. Select OK to close the New Connections Properties window.
To use TCP/IP applications (Telnet, HTTP, and SNMP) over your PPP
serial port interface:
1. Open My Computer on your PC.
2. Double-click Dial-Up Networking. The Dial-Up Networking program
folder opens.
*Note: You must have dial-up networking installed on your PC.
3. Double-click the PPP modem you previously created. The Connect To
window opens.
4. Enter your password and select Connect. A Pre-Dial Terminal screen
opens.
When the modem has successfully connected, a Post-Dial Terminal
screen opens.
5. Login in the Post-Dial Terminal screen using your CLI user name and
password. It may be necessary to enter several carriage returns to view
the Login prompt.
6. At the CLI prompt, go to configuration mode.
7. Enter set console transfer PPP . ASCII characters display
below the CLI prompt. This is typical while the switch attempts to
connect via PPP.
8. Select Continue (F7) from the Post-Dial Terminal screen. PPP
verification completes and the Connected To window displays a
message that the modem connection has been successfully established.
User Guide for the Avaya P580 and P882 Multiservice Switches, v6.1