Setting The System Clock - Avaya 580 User Manual

CLI Command

Setting the System Clock

Web Agent
Procedure
Document No. 10-300077, Issue 2
Table 3-2. One-Time Summer Time Hours Configuration
Parameter Definition
Start Specifies the start of Summer Time Hours.
End Specifies the end of Summer Time Hours.
To set Summer Time Hours that are not based on a standard rule using the
CLI, enter the following command from Configure mode:
(configure)# clock summer-time date
The system clock is used for setting traps, alarms, and other events on the
switch.
* Note: You must set SNTP and Summer Time Hours before you can set
the system clock. See
Protocol" and
chapter.
* Note: The system clock does not automatically change with Daylight
Savings Time.
You can set the system clock from either the Web Agent or the CLI.
To set the system clock using the Web Agent:
1. In the navigation pane, expand the System > Configuration folders, and
then click System Clock. The System Clock Web page is displayed in
the content pane. See
Configuring System Information
"Enabling the Simple Network Time
"Setting Summer Time
Figure 3-6.
2 of 2
Hours" earlier in this
3-11