Table of Contents
Advertisement
Chapter 12
CLI Command
Modifying IGMP Interfaces
Web Agent
Procedure
12-32
Figure 12-15. IGMP Global Configuration Web Page
4. Select Enable from the IGMP field pull-down menu to enable IGMP.
5. Select Enable from the MTRACE field pull-down menu to enable
MTRACE processing.
6. Click APPLY to save your changes, or CANCEL to restore previous
settings.
To globally enable IGMP using the CLI, enter the following command from
Configure mode:
(configure)# set router igmp
To modify IGMP interfaces from the Web Agent:
1. In the navigation pane, expand the Routing > IGMP folders, and then
click Interfaces. The IGMP Interfaces Web page is displayed in the
content pane. See
Figure
*Note: You must first enable "multicast protocol"on an interface
before you can configure IGMP. See
IP
Interfaces" earlier in this chapter for more information
on how to select a multicast protocol.
User Guide for the Avaya P580 and P882 Multiservice Switches, v6.1
12-16.
"Displaying Existing
Advertisement
Table of Contents
