Table of Contents
Advertisement
CLI Command
Document No. 10-300077, Issue 2
Table 14-2. RIP Interface Web Page Parameters
Parameter
Allows you to...
Default Metric
Specify the RIP route metric value. Costing metric used
when advertising the RIP route on this interface.
1 is the default setting. The parameter range is 0-15.
Default Route
Specify the mode for the default route learning on this
interface. Different states include:
Disable is the default setting.
Auth Type
Specify the type of authentication available for use on a
given RIP interface. Authentication types include:
None is the default setting
Auth Key
If Auth Type is:
None is the default setting.
To modify RIP interfaces parameters using the CLI enter the following
command from Configure mode:
(configure)# interface <intf-name> | [type {mbna | ethernet}]
• Disable - Disables the default route.
• Talk Only - Send RIP information to the network.
• Listen Only - Receive RIP information from the
network.
• Talk/Listen - Both send and receive RIP information
from the network.
• None - No authentication required.
• Simple - Uses a clear-text password for validation.
This password is sent unencrypted across the network
to neighboring RIP routers.Available for RIP V2 only.
• MD5 - Uses an encrypted Key to validate RIP V2
routing updates from neighboring RIP V2 routers.
• None - leave this field blank, or this field is ignored.
• Simple - Enter the clear-text password for validating
RIP packets from neighbor RIP V2 routers.(1-16
characters)
• MD5 - Enter the defined Key Chain values under
Routing > IP > RIP > Key Chains.
Configuring RIP Routing
2 of 2
14-5
Advertisement
Table of Contents
