Table of Contents
Advertisement
Document No. 10-300077, Issue 2
Table 17-2. Add IPX RIP Filters Web Page Parameters
Parameter
Select
Interface
Precedence
Start Network
End Network
Direction
Filter/Suppress
Configuring the IPX RIP Protocol
Allows you to...
The Select chechbox selects the IPX Interface. This box
only appears with the IPX RIP Filters Web page.
Select the interface to which this filter will be applied to
RIP packets sent and/or received on the interface.
Specify the filter precedence (in order of importance)
with 0 equal to most important.
Note:
All filters on the same interface, must be
assigned a unique filter precedence.
Specify the first IPX network number in the range.The
default is 0
Specify the last IPX network number in the range.The
default is 0
Select the direction of the filter from a pull-down menu.
The pull-down filter menu options are:
• Inbound - Apply the filter only to RIP packets
received on the interface.
• Outbound - Apply the filter only to RIP packets
sent on the interface.
• Both - Apply the filter to RIP packets both sent
and received on the interface.
• The default is Outbound
Disable the IPX networks (within the specified range in
the filter) to be filtered (inbound) or suppressed
(outbound).
• Filtered - Apply the filter only to RIP packets
received (inbound direction) on the interface.
• Suppressed - Apply the filter only to RIP packets
sent (outbound direction) on the interface.
Enable allows you to filter and suppress traffic and is
the default. Select Disable to disable the filtering and
suppression of traffic.The default is Enable
1 of 2
17-5
Advertisement
Table of Contents
