Installing Ethernet Routing Switch 4900 Series
Console port pin assignments
The following table describes the console port pin assignments.
Table 8: RJ–45 Console port pin assignments
Connector
Equipment requirement
After unpacking this switch, check the contents to be that sure you have received all the
components. Then, before beginning the installation, be sure that you have all other necessary
installation equipment.
Verifying the package contents
For each Ethernet Routing Switch 4900 Series, verify the package contents with the items in the
following figure to ensure you have received all components. If any components are missing,
contact the vendor where you purchased the switch.
February 2016
Pin Number
Signal
1
Ready to send (RTS) — optional
2
Data terminal ready (DTR) — optional, can swap or link with pin
8
3
Transmit data (TXD) — mandatory
4
Carrier detect (DCD) — optional
5
Ground (GND) — mandatory
6
Receive data (RXD) — mandatory
7
Data set ready (DSR) — optional
8
Clear to send (CTS) — optional, can swap or link with pin 1
Installing Avaya Ethernet Routing Switch 4900 Series
Comments on this document? infodev@avaya.com
22