CLI Command
Deleting an AppleTalk Interface
Web Agent
Procedure
CLI Commands
Document No. 10-300077, Issue 2
To edit an AppleTalk interface using the CLI, enter the following command
from Interface mode:
(config-if:<interface-name>)# appletalk <options>
You can delete an AppleTalk interface using either the Web Agent or the
CLI.
To delete an AppleTalk interface using the Web Agent:
1. In the navigation pane, expand the Routing > AppleTalk >
Configuration folders, and then click Interfaces.
The AppleTalk Interfaces Web page is displayed in the content pane.
See
Figure
19-4.
2. Select the AppleTalk interface that you want to delete from the Select
column.
3. Click DELETE to remove the AppleTalk interface.
Use the following CLI commands in interface mode to delete an AppleTalk
interface:
(config-if:<interface-name>)# no appletalk cable-
range <cable-range>
(config-if:<interface-name>)# no appletalk address
<network.node>
(config-if:<interface-name>)# no appletalk zone
<zone-name>
(config-if:<interface-name>)# no appletalk vlan
<vlan-id>
Configuring AppleTalk Routing
19-9