Enabling Ip Routing Global Parameters - Avaya 580 User Manual

Chapter 12
CLI Commands

Enabling IP Routing Global Parameters

12-10
Table 12-1. Add IP Interface Web Page Fields
Parameter Allows you to...
Multicast Protocol Specify the multicast protocol for the interface. Options
include:
* Note: By Default, multicast forwarding is
Proxy ARP Enable or disable Proxy ARP. The default value is
Disable.
ICMP Redirect Enable or disable ICMP Redirect (IDRP). The default
value is Enable.
NetBIOS UDP Enable or disable NetBIOS UDP Rebroadcasts. The
Rebroadcast default value is Disable.
VRRP Enable or disable Virtual Redundancy Router Protocol.
The default value is Disable.
BOOTP/DHCP Enable or disable the BOOTP/DHCP Relay Agent. The
Relay Gateway default value is Enable.
To create an IP interface, you must use two CLI commands:
1. Create an Interface Name first.
(configure)# interface <interface_name> type <ethernet |
nbma>
Example: (configure)# interface myif type ethernet
2. Assign an IP address to the interface.
(confg-if:myif) # ip address <ip-address> <mask>
Example: (config-if:myif)# ip address 192.168.97.1
255.255.255.0
You can enable IP Unicast Forwarding (Routing) Globally using either the
Web Agent or the CLI.
User Guide for the Avaya P580 and P882 Multiservice Switches, v6.1
• None (Default)
• DVMRP
• IGMP
disabled. To enable multicast forwarding
go to the IP Global Configuration page.
3 of 3