Table of Contents
Advertisement
Chapter 8
Using the All Ports Configuration Web Page
Configuring Switch Ports Settings
8-28
You can apply the same parameter settings on all of a module's ports using
the All Ports Configuration Web page.
To configure all ports on a module:
1. In the navigation pane, expand the Modules & Ports folder, and then
click Configuration. The Module Information Web page is displayed in
the content pane. See
2. Select the port number from the Ports column for that module. The
Physical Port Configuration Web page for that module is displayed. See
Figure 8-5
for Gigabit modules and
3. Select All Module Ports Configuration. The All Ports Configuration
Web page is displayed.
4. See
"Configuring Physical Ports on 10-Gigabit
Physical Ports on Gigabit
Fast Ethernet
Ports" earlier in this chapter to configure the ports.
5. Click APPLY to save your changes, or Restore to restore previous
settings.
This section contains the following information and procedures:
Configuring Switch Ports
Automatic VLAN Creation
Configuring MAC Address Lock and Intrusion Detection
Using the All Module Ports Configuration Web Page
Viewing Switch Port Settings
User Guide for the Avaya P580 and P882 Multiservice Switches, v6.1
Figure
8-2.
Figure 8-7
Ports," and
"Configuring Physical Ports on
for 10/100 modules.
Ports,"
"Configuring
Advertisement
Table of Contents
