Table of Contents
Advertisement
CLI Command
Viewing IGMP Snooping Statistics
Web Agent
Procedure
Document No. 10-300077, Issue 2
2. Select Enable from the State field.
3. Click APPLY to complete the operation or CANCEL to ignore the
operation.
Table 20-8. IGMP Snooping Web Page Parameters
Parameter
Enable State
Intelligent Multicast
Session Statistics
To enable IGMP Snooping using the CLI, enter the following command
from Configure mode:
(configure)# set igmp-snooping enable
You can view IGMP snooping statistics using either the Web Agent or the
CLI.
To view IGMP snooping statistics using the Web Agent:
1. In the navigation pane, expand the L2 Switching > Intelligent
Multicast folders, and then click IGMP Snooping.
The IGMP Snooping Web page is displayed in the content pane. See
Figure
20-11.
2. See
Table 20-8
for an explanation of the IGMP Snooping Web page
parameters:
Managing Intelligent Multicasting
Definition
Select Enable to allow the IGMP snooping on the
interface. The default value is Disable.
• New Sessions Created - Displays the number
of new sessions created by IGMP snooping.
• Sessions Destroyed - Displays the number of
sessions removed by IGMP snooping.
• New Client Ports Added - Displays the
number of new client ports added by IGMP
snooping.
• New Router Ports Added - Displays the
number of new router ports added by IGMP
snooping.
• Router Ports Removed - Displays the number
of router ports removed by IGMP snooping.
20-21
Advertisement
Table of Contents
