Configuring Irdp; Enabling Irdp On An Interface - Avaya 580 User Manual

Configuring IRDP

Enabling IRDP on an Interface

Web Agent
Procedure
Document No. 10-300077, Issue 2
ICMP Router Discovery Protocol (IRDP) is an alternative router discovery
protocol using ICMP messages on multicast links. ICMP uses router
discovery messages, known as router advertisements and router
solicitations.
Each router periodically multicasts a router advertisement from each of its
multicast interfaces, announcing the IP address of that interface, and other
router IP addresses. Hosts discover the addresses of their neighbor routers
by listening for the advertisements. When a host attached to a link starts up,
it may multicast a router solicitation to ask for immediate advertisements,
rather than waiting for the next periodic one to arrive.
If no advertisements arrive, the host re-transmits the solicitation, but does
not send additional solicitations. Routers that subsequently start up, or were
not discovered because of packet loss or temporary link partitioning, are
eventually discovered by reception of their periodic (unsolicited)
advertisements.
You can enable IRDP on an interface using either the Web Agent or the
CLI.
To enable IRDP on an interface using the Web Agent:
1. In the navigation pane, expand the Routing > IP > Configuration
folders, and then click IRDP.
The ICMP Router Discovery Protocol Web page is displayed in the
content pane. See Figure
Figure 12-40. ICMP Router Discovery Protocol Web Page
12-40.
Configuring IP Routing
12-83