Table of Contents
Advertisement
CLI Command
Enabling VRRP on an Interface
Document No. 10-300077, Issue 2
Figure 12-35. IP Global Configuration Web Page
2. Select Enable from the VRRP field pull-down menu.
3. Click APPLY to save your changes, or CANCEL to restore previous
settings.
To globally enable VRRP from the CLI, enter the following command in
Configure mode:
(configure)# router vrrp
VRRP can be enabled on an interface using the Web Agent or the CLI.
* Note: For VRRP to function correctly, it must be enabled globally and
enabled on the interfaces on which any virtual routers are to be
created. Otherwise, any virtual routers created will be in the
Initialize state (see
Table
12-32).
Configuring IP Routing
12-73
Advertisement
Table of Contents
