Creating Extended Access Rules - Avaya 580 User Manual

Chapter 13

Creating Extended Access Rules

13-8
Table 13-1. Create Standard IP Access List Web Page Parameters
Parameter Allows you to...
Access List The Avaya Multiservice switch supports ACL names up to
Name 32 characters (Alpha-Numeric). Spaces are allowed in the
names but are not recommended. Instead of spaces, use the
underscore "_" character.
See
Access Rule Enter the sequence number for each new rule you create.
Index Index numbers can be 1 through 512. Packets are compared
against rules in ascending index order.
Note:
Access Type Select the method of handling incoming datagrams based on
the IP access type from the following pull-down menu
options:
Source Subnet
4. Click CREATE to save your changes, or CANCEL to restore previous
settings.
To create Extended Access Rules:
1. In the navigation pane, expand the Routing > IP > Configuration
folders, and then click Access Lists.
The IP Access List Web page is displayed in the content pane. See
Figure 13-1.
User Guide for the Avaya P580 and P882 Multiservice Switches, v6.1
"Naming Conventions for
Entering a new rule may override other rules.
Review your current configuration prior to creating
new access list rules.
• Deny/Filter - Allows you to filter out (drop) packets
based on the specified configuration.
• Permit/Fwd pri8 (high) to pri1 (low) - Allows you
to prioritize traffic based on the specified
configuration.
• Permit/Fwd with no change in priority - Allows
you to forward traffic with no change in priority.
• Source Address - Enter the IP address that you want
to deny or grant access to the switch. The Wildcard
will determine how the address is evaluated.
• Source Address Wildcard - Enter the Wildcard for
this address. For more information on wildcards, see
"What are Wildcards?" earlier in this chapter.
ACLs" for more information.