Table of Contents
Advertisement
Chapter 20
CLI Command
Managing the LGMP Server
Configuring the LGMP Server
Web Agent
Procedure
20-22
3. Click:
CLEAR to clear the statistics.
—
REFRESH to refresh the contents of the table.
—
To view IGMP snooping statistics, use the following CLI command:
> show igmp-snooping statistics
This section provides the following procedures for managing the Lucent
Group Management Protocol (LGMP) Server:
Configuring the LGMP Server
Viewing the LGMP Server Statistics
Viewing the LGMP Server Statistics per VLAN
You can configure the LGMP server using either the Web Agent or the CLI.
To configure the LGMP server using the Web Agent:
1. In the navigation pane, expand the L2 Switching > Intelligent
Multicast folders, and then click LGMP Server.
The LGMP Server Configuration Web page is displayed in the content
pane. See
Figure
20-12.
*Note: You must enable intelligent multicasting on a global basis
to activate the LGMP Server. LGMP serving is only
active on VLANs with an IGMP interface enabled and
IGMP snooping globally enabled.
User Guide for the Avaya P580 and P882 Multiservice Switches, v6.1
Advertisement
Table of Contents
