Table of Contents
Advertisement
18
Overview
Configuring IPX SAP Interfaces
Web Agent
Procedure
User Guide for the Avaya P580 and P882 Multiservice Switches, v6.1
Configuring the IPX SAP
Protocol
The information and procedures provided in this chapter pertain to layer 3
module configuration only. This chapter provides information about the
Internetwork Packet Exchange (IPX) Service Advertising Protocol (SAP)
and procedures for the following tasks:
Configuring IPX SAP Interfaces
Creating IPX SAP Filters
Interpreting IPX SAP Interface Statistics
For more information about the CLI commands that are mentioned in this
chapter, see Command Reference Guide for the Avaya P580 and P882
Multiservice Switches, Software Version 6.1
You can configure IPX SAP using either the Web Agent or the CLI.
To configure the IPX SAP interfaces using the Web Agent:
1. In the navigation pane, expand the Routing > IPX > SAP folders, and
then click Interfaces.
The IPX SAP Interfaces Web page is displayed in the content pane. See
Figure
18-1. If no IPX interfaces are configured, then the No
Interfaces are currently configured message is
displayed.
18-1
Advertisement
Table of Contents
