Creating Access Rules; Creating Standard Access Rules - Avaya 580 User Manual

Chapter 13

Creating Access Rules

Creating Standard Access Rules

13-6
This section contains the following procedures:
Creating Standard Access Rules
Creating Extended Access Rules
To create standard access rules:
1. In the navigation pane, expand the Routing > IP > Configuration
folders, and then click Access Lists.
The IP Access List Web page is displayed in the content pane. See
Figure 13-1.
*Note: The IP Access List displays all standard and extended
access rules that have been created. If no rules have been
created, the following statement displays: No IP
Access Rules are currently configured .
Due to its size,
page split in two separate sections.
The switch supports a maximum total of 512 access
control rules, regardless of the number of access lists. For
example, you could create the following three ACLs:
• ACL A with 100 rules
• ACL B with 200 rules
• ACL C with 212 rules
The combined total of rules cannot exceed 512. Only one
access control list can be enabled at a time.
Index numbers of access rules can range from 1 to 512. Do
not use index numbers higher than 512.
User Guide for the Avaya P580 and P882 Multiservice Switches, v6.1
Figure 13-1 shows the Access List Web