Table of Contents
Advertisement
Chapter 15
15-10
11. Reenable the interface:
a. In the navigation pane, expand Routing > IP > Configuration
folders.
b. Click Interfaces.
The IP Interfaces Web page is displayed in the content pane.
c. Select the Select check box for the interface that you want to
reenable.
d. In the Admin. State column for the interface that you want
modified, select UP.
e. Click Apply.
Table 15-3. OSPF Interface Web Page Parameters
Parameter
Definition
Select
Select the OSPF interface to be modified.
Interface
Displays IP interface (VLAN) that has OSPF enabled.
Note:
IP Address
Displays IP address associated with the OSPF interface.
Note:
Area
Enter the area ID configured for this interface. The default
is 0.0.0.0.
DR Priority
Enter the decimal value for this interface for DR priority
functionality. The value range is 0-255. The default is 1.
Transmit Delay
Enter the estimated time (seconds) it takes to transmit a link
state update packet over this interface.The value range is 1-
3600. The default is 1.
Retransmit
Enter the time (seconds) between link-state advertisement
Interval
retransmissions, for adjacencies belonging to this interface.
This value is also used when retransmitting database
description and link-state request packets. The value range
is 1-3600. The default is 5.
Hello Interval
Enter the time (seconds) between the Hello packets that the
router sends on the interface. This value must be the same
for all routers attached to a common network. The value
range is
1-65535. The default is 10.
User Guide for the Avaya P580 and P882 Multiservice Switches, v6.1
This is a read-only field.
This is a read-only field.
1 of 2
Advertisement
Table of Contents
